Step By Step Guide For Steroid Homebrewing

Step By Step Guide For Steroid Homebrewing:

In this guide I will be brewing Testosterone Enanthate. I made 10 bottles each dosed at 250mg/ml. Alright lets get started the pictures will do alot of the talking.

– An article from elitefitness

Supplies:

  • Scale (Get one that is sensitive enough to the gram)
  • Vaccum pump(Brake Bleeder)
  • 250ml Nalgene/Millipore Filter
  • 25grams of Testosterone Enanthate powder
  • 18ml of Benzyl Benzoate (BB) (USP)
  • 2ml of Benzyl Alcohol (BA) (USP)
  • 61.25ml of Grapeseed oil
  • 3ml syringe with 18-21 gauge needle
  • 20ml syringe with 18-21 gauge needle
  • Small piece of paper
  • 500ml beaker
  • 100ml beaker
  • 10 10ml vials
  • 10 rubber stoppers
  • 10 flip caps
  • Crimper

This is way more than 25grams but i’ll show how to measure out. Sounds simple but its kinda tricky.

All right lets beginFirst you weigh out your powder. Now you have to do this very carefully. get your small piece of paper and place it on the scale then press tare to set it to zero so it doesnt weigh the paper. Then slowly add your powder. Now here is the tricky part the powder weighs so little that the scale needs to be reset every time you add some. All you have to do is add some then press on the scale with your finger and let the number fall back down. Once you get 25 grams your good to go.

Then dump it into your beaker.

Add 2ml of Benzyl Alcohol (BA) (USP)

Then add 18ml of Benzyl Benzoate BB) (USP)

Next step is sort of optional but its makes things easier. Get a pot with a bout an inch of water in it and place it on the stove and set the eye to 3.

Put the beaker in it.

Watch the powder dissolve and the mixture get pretty close to clear.

Next add you grapseed oil and let it all warm up for a bit to make filtering a little bit faster. This is a pic right after I added the oil. In put it back on the eye for a minute and mixed it.

Then get your filter which comes with a cap for the bottom collection part.

Next pour the oil in and attach the vacuum pump and set it between 300-400. THIS IS THE SAFETY ZONE. DONT PUSH YOUR LUCK THE BOTTOM PLASTIC CONTAINER WILL CRACK.

Filtering (The flash on the camera makes the oil look kinda hazy)

Done the whole filtering process takes about 30 minutes but all you have to do is pump and walk away.(Edit by WUMEITECH)

Next you measure out 10ml in each vial

I put the rubber stopper and flip tops on them but didnt crimp them yet.
Then you crimp.

And now your done. You have now made 100ml of Test E and put in 10 10ml vials. If you have questions pm me.

Now you can start to home brew either steoid powder or steroid semi finished liquid, it is easy.

If you have question, contact with our service person, we will get back to you timely.

Edited by Wumei Tech, All Rights Reserved.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s